ASTM D1003
Standardtestmetode for uklarhed og lystransmission af transparent plast
ASTM D1003 is a standard test method for measuring the haze and luminous transmittance of transparent plastics. Haze is a measure of the amount of light that is scattered by particles in a transparent material. Luminous transmittance is a measure of the amount of light that passes through a transparent material.
The test method is applicable to transparent plastics that are at least 1.5 mm thick. The sample is placed in a haze meter, and the amount of light that is scattered and transmitted is measured. The haze is then calculated from the measurements.
The test method provides two procedures for measuring haze:
- Procedure A: This procedure uses a hazemeter that is equipped with a 2.5° integrating sphere.
- Procedure B: This procedure uses a spectrophotometer that is equipped with a 2.5° integrating sphere.
Procedure A is the preferred procedure, as it is more accurate and reproducible. However, Procedure B can be used if a spectrophotometer is the only instrument available.
The test method also provides specifications for the haze and luminous transmittance of transparent plastics. The haze specifications vary depending on the application of the plastic. For example, the haze specification for a plastic that is used in a window is typically lower than the haze specification for a plastic that is used in a food packaging material.
ASTM D1003 is a valuable tool for quality control in the plastics industry. It can be used to ensure that plastics meet the required haze and luminous transmittance specifications.
Here are some of the key requirements of ASTM D1003:
- The hazemeter or spectrophotometer must be calibrated with a standard reference material.
- The hazemeter or spectrophotometer must be able to measure haze and luminous transmittance over a range of values.
- The hazemeter or spectrophotometer must be able to produce accurate and reproducible results.
- The sample must be clean and free of defects.
- The sample thickness must be at least 1.5 mm.
By meeting these requirements, ASTM D1003 can be used to reliably measure the haze and luminous transmittance of transparent plastics.
Alle vores testinstrumenter og testudstyr og produktionsmaskiner er designet og konstrueret i overensstemmelse med anerkendte internationale teststandarder, herunder ASTM, AATCC, CIE, DIN EN ISO, MIL, Ford, Renault, AS NZS, TAPPI og mange flere.
Alle vores produkter er omhyggeligt kalibreret for at sikre den forventede høje nøjagtighed af din forskning og dine kvalitetsstyringsstadier og prøvetest.
Derudover er vi altid her for at hjælpe med yderligere kalibreringstjenester på vores kalibreringscentre.
Support
Kundeservice på alle stadier og loyalitet over for vores kunder, professionel service og at levere de bedste kvalitetsprodukter, instrumenter og maskiner er fire af vores topprioriteter for at sikre, at du og dine ekspertteams vil være begejstrede og glade for den pålidelige kvalitet af vores produkter, instrumenter og maskiner. Qualtech Products Industry har udviklet og indført et kvalitetssystem og er ISO 9001:2000 certificeret. Vi er forpligtet til at evaluere og implementere kvalitetsforbedringer gennem alle vores forsknings- og produktionsprocesser ved at sikre, at "kvalitet leveres til din virksomhed". Spørg venligst vores venlige teams om support, mere information, detaljer og tilgængelige tjenester for at bringe reelle værdier til dig som vores vigtige kunde.
Dansk 
English 
Deutsch 
Ελληνικά 
Español 
Español de México 
Suomi 
Français 
Français du Canada 
Italiano 
Nederlands 
Svenska 
Português